Pro-Extreme

Rig

Every line at once: steer, trim, move the crew, and watch the heel and the speed.

Loading the boat…
Drag to look around. Pinch, or hold ⌘ or Ctrl and scroll, to zoom.

Pick a heading on the chart and pull in the sails.

N Wind
Use the real wind on Port Phillip.
Point of sail
–
True wind
–
Apparent
–
Heel
–
Helm
–
Leeway
–
Hull
–
Mainsail
–
Jib
–
Spinnaker
–
Made good
–
Boat speed, the last 40 seconds

How to use it

Steer on the chart: drag around the circle, or use the arrow keys. Then trim. The speed in the top corner is the result of everything you set, and the line under the boat suggests the change that would help most right now.

Try one control at a time and watch the speed trace. Then try the same thing in a different wind: what is fast in 6 knots is often slow in 18.

Challenge a friend beta. Two sailors take turns on the same device, in the same wind and on the same course: the live wind on the Bay when it is fair for trimming, otherwise a random breeze between 8 and 15 knots. Each starts from the same neutral trim with the speed hidden, sets the boat up by the telltales, the heel and the helm, and locks it in. Each turn has a clock, 30 seconds to 5 minutes, chosen at the start; when it runs out, the settings lock in by themselves. Then the coach ranks you against the fastest settings it can find, and shows each of you the changes that would have helped most.

Online, each on their own beta. Start a challenge and share its four-letter code or link; everyone sails it on their own phone or computer, until the end time you set, up to a week ahead: the next club night, say. The board fills as sailors lock in, and every device shows it. For a class, give everyone a clock, 1 to 10 minutes from Sail it: when it runs out, each sailor’s settings lock in and go to the board by themselves. Give an email address when you start it, and the final board goes there when it ends; then the challenge is deleted. See Privacy for what is kept.

Set the boat up your way first. Then “Coach mode” moves every control to the fastest setting the model knows for this heading and wind, lists each change it made with the speed it adds, and explains why, line by line. “Back to my settings” and “Fast settings” switch between the two. It is the model’s answer, not a rule: compare it with what your coach says, and with what works on the water.

What each control does

Mainsheet
Sets the angle of the boom; the number beside it shows how far out the boom sits. Too far out and the sail flaps (luffs); too far in for the course and the flow breaks away (stalls). Hard on, the boom comes to about the centreline and the leech pulls tight: right for close-hauled in a light or moderate breeze, too much as soon as you bear away.
Vang (kicker)
Holds the boom down. More vang closes the top of the sail; less lets it twist open and spill wind. On the ILCA it also bends the mast and flattens the sail.
Outhaul
Tightens the foot. Tight is flat and easier to hold in a breeze; eased is full and powerful in light wind.
Cunningham
Pulls the front of the sail down. It moves the deepest part forward and opens the top.
Jib sheet and car
The sheet sets the jib’s angle. Hard on, it stops at the fairlead, about 13° out on the RS Quest, and can come in no further. Moving the car aft flattens the foot and opens the top, so the top telltales lift first; forward makes the foot fuller and closes the top, which can choke the gap to the mainsail. A jib pulled in much harder than the main blows wind onto the back of the mainsail. The RS Quest’s jib leads are fixed: untick “Fixed leads” to see what a car would do. On the water the difference is about a tenth of a knot, and it shows most in the telltales.
Telltales
Short ribbons on the sail, red on the port side and green on the starboard side. On the jib (and the ILCA’s main) they sit near the front: when both stream aft, the trim is right. The windward one lifting means the sail is too far out, or you are pointing too high; the leeward one drooping means it is pulled in too far. The ones on the main’s back edge stream aft when the air leaves the sail cleanly, and curl round behind it when the leech is too tight. The Telltales view brings the camera in close.
Leeway
Upwind the boat slides a few degrees sideways as well as forwards. That means the sails meet the wind from slightly further ahead than the heading suggests, which is one reason the sheets can go hard on close-hauled. Lift the board and the leeway grows.
Asymmetric spinnaker (RS Quest)
Flown from the bowsprit, for reaching and broad reaching. Close-hauled it collapses; dead downwind the main hides it, so sail a little higher and gybe instead. Trim by easing the sheet until the luff just curls, then trim a touch: over-sheeted, it stalls and heels the boat. RS Sailing’s guidance: within the crew’s skill up to 15 knots, and in the bag from 18.
Board
Down to stop the boat sliding sideways upwind; up to cut drag downwind. Raising it also changes the feel of the helm.
Crew
Weight to windward holds the boat up, and a flat boat is fast. In light wind, sitting out too far heels her to windward instead. Heavier crews carry more power in a breeze and are slower in light air.
Fore and aft
Forward in light wind keeps the stern from dragging; back when she starts to plane.
Reef and furl (RS Quest)
RS Sailing reefs the Quest’s main at 18 knots, before launching, and furls the jib in stronger wind. The boat is certified to Force 6, about 27 knots. Experience, a reefed rig and enough crew weight are what count, and a light crew reaches each step sooner. The note under the boat says what applies in the wind you have set, and links to our wind limits page.
Hull speed and planing
At about 4.8 knots a 4-metre dinghy is sitting in its own wave system: a bow wave, and a stern wave just behind the transom. To go faster she has to climb her bow wave and plane. That takes power and a flat boat, and it starts at around 7 knots. The bow and stern waves in the 3D view show where she is.

About the model

This is a teaching model, not an engineering one. The sails make lift and drag from their angle and shape; the crew and the hull hold the boat up against the heel; speed is where the drive meets the resistance.

The boat figures come from the makers: the RS Quest from RS Sailing, the ILCA from the class. Everything else is an estimate. The speeds are right in proportion, not to the decimal, and there are no waves.

The RS Quest is our own model of Aurora, built from photographs.

Steer with the chart. In the 3D view, drag to look around; pinch, or hold ⌘ or Ctrl and scroll, to zoom. Full screen fills a big display for a class.