Keep it upchartroom ↑

Foiling Beta

Boats that fly: how a small wing under the water lifts a whole boat and sailor out, and keeps them up.

Wings under water: lift and take-off, the drag hump, holding the ride height, foil shapes, and sailing faster than the wind.

Lift in a fluid 830 times denser than air, the take-off hump, heave stability and control, foil geometry, and apparent wind at speed ratios of two and more.

For new sailors, about ten years old and up.

For sailors who know the basics, about sixteen and up.

For the technically curious.

Beta: still being tuned. The models here are simple and made to show one thing each. If something feels wrong against what you know from the water, the Feedback button is the quickest way to say so.

  1. 1 A wing under the water
  2. 2 Taking off
  3. 3 Ride height and the wand
  4. 4 Foil shapes
  5. 5 Who flies, and on what
  6. 6 Faster than the wind
  7. 7 Where next

1A wing under the water

A foil is a small wing that goes under the boat, in the water. When the boat goes fast enough, the foil lifts the whole boat out of the water, the same way the sail’s wind pulls the boat along, but upwards.

Then only the thin foils are in the water, so the boat goes much, much faster.

Lots of boats fly now: little dinghies like the Moth in the picture and the WASZP, windsurfers and kiteboards at the Olympics, the Olympic Nacra 17 catamaran, and the giant racing boats of SailGP and the America’s Cup.

A hydrofoil works like a sail or an aircraft wing: it turns the water flowing past it, and the water pushes back. Water is about 830 times denser than air, so a foil the size of a laptop can carry a boat and its sailor.

Lift grows with the square of speed. Below take-off speed the hull still floats; above it, the foil carries everything.

Three of the Olympic classes fly: the iQFOiL windsurfers, the Formula Kite riders and the mixed Nacra 17 catamaran, at Paris 2024 and again at Los Angeles 2028. Club sailors usually learn on a WASZP or a Moth.

Lift = ½ ρ V² A CL, with ρ ≈ 1025 kg/m³. A Moth’s main foil of about 0.14 m² at a CL of 0.8 carries 105 kg at about 4.2 m/s, or 8 knots.

Once she is flying, the hull’s wave-making and skin drag are gone; what remains is the profile and induced drag of the foils and the drag of the struts. That is the whole trick.

The Olympic foilers show the range of control: iQFOiL and Formula Kite fly T-foils with no mechanism at all, the rider’s stance doing the work; the Nacra 17 uses curved boards and rudder elevators; the Moth, here, a wand and a flap.

A foiling Moth: a single-handed dinghy, 3.4 m long, that flies on two foils.The Moth: main T-foil under the middle, an elevator on the rudder, and a wand at the bow.Main foil for lift and height (flap), rudder elevator for pitch, wand for height sensing.

2Taking off

Slide the speed up. At first the foil helps a little and the boat still sits in the water. Then, at about 8 knots, the foil lifts the whole boat and she flies.

After that, going faster is easier, because there is so much less to push through the water.

Below take-off the hull pushes water aside and makes waves, and drag rises to a hump. Past take-off the hull leaves the water and drag drops sharply, even though the boat is going faster.

Getting over that hump is the hard part: in light wind a foiler needs a gust, or some pumping, to get up. Try a smaller foil: take-off moves to a higher speed.

Hull resistance (skin friction plus a wave-making peak near hull speed) falls away as the foil takes the weight. Foil drag is profile, growing with V², plus induced, growing with L²/V², so it is lowest just after take-off and then climbs slowly.

More area or more flap lowers the take-off speed but costs drag at the top end: the designer’s trade-off. The model: hull drag 9V² plus a wave hump near 2.4 m/s, scaled by the share of weight still on the hull; foil CD0 0.012, span 1 m.

Blue arrow: lift from the foil. Black arrow: the weight of boat and sailor. When blue is as long as black, she flies.The chart: drag of the hull alone (dashed) and of the foiling boat (solid). The hump comes before take-off.A simple model to show the shape of the curve: not a velocity prediction.

3Ride height and the wand

Once she is flying, the boat has to stay at the right height. Too high and the foil pops out of the water and she crashes; too low and the hull hits the water and slows down.

A stick at the front, the wand, feels the water and moves a flap on the foil, all by itself. Try flying without it!

A fully submerged T-foil gives the same lift at any depth, so on its own nothing holds the height: the boat drifts up or down. The Moth’s wand senses the height at the bow and moves the main foil’s flap through a pushrod: lower means more flap and more lift.

It is a simple mechanical autopilot, and the reason Moths can fly at all.

Heave is neutrally stable for a submerged foil (dL/dh ≈ 0), and unstable near the surface, where ventilation removes lift abruptly and only returns deeper down. The wand closes the loop: flap proportional to gain × (set height − sensed height).

Too little gain and she cannot follow the waves; too much, with the lag in the linkage, and she porpoises. Bigger foilers replace the wand with sensors and a flight controller doing the same job.

4Foil shapes

Not every foil needs a wand. Some foils are curved, or shaped like a V, and poke up out of the water. The higher the boat rises, the less foil is left under the water, so it lifts less, and the boat settles at a height of its own.

A T-foil, like the Moth’s, does not do that. It lifts the same at any depth, so something has to hold the height: the wand, a crew member, or the rider’s feet. Pick a boat in the picture, move her up or down, and let go.

The big ocean racers, the IMOCA 60s of the Vendée Globe, have huge curved foils that lift most of the boat. Their rules allow no foils on the rudders, so they never quite fly: they skim.

Surface-piercing V-foils find their own height: lift falls as more of the foil leaves the water. T-foils do not, so they need control, from a wand, a flight controller or the rider, but they fly deeper, more efficiently and with less fuss from waves. Almost every racing foiler now uses them: the Moth, the WASZP, the Olympic iQFOiL and Formula Kite, the AC75 and, since 2025, SailGP’s F50.

Curved boards, like the Nacra 17’s, sit in between: lift falls as the bend rises out of the water, and the upright part pushes sideways, like a centreboard. The IMOCA 60’s foils come out low on the side of the hull, run down and then outwards, curving up towards the tip: the steep part resists leeway like a daggerboard, the flat part deep down lifts much of the boat. The class allows no foils on the rudders, so nothing holds her trim: she skims rather than flies.

Height stability needs dL/dh < 0. Surface-piercing foils get it from immersed span; curved boards and L-foils partly, as the bend emerges; T-foils not at all, and rely on active control: the Moth’s wand and flap, the flight controller on an AC75 or F50, or the rider’s stance on a board.

The trade-off: self-stabilising foils run near the surface, with its ventilation and waves; controlled foils fly deep and efficiently. SailGP’s F50 raced on L-foils until 2024 and moved to T-foils in 2025 for more top speed. The IMOCA rule allows no lifting surfaces on the rudders, so without pitch control the boats skim on their foils rather than fly.

T-foil: the Moth

Pick a boat, move her up or down, then let go. Where does she settle by herself?Where the blue line crosses the weight line, the boat has a ride height of her own.Illustrative lift curves, chosen to show the slope that matters: not measured data.

5Who flies, and on what

The shape of the foil tells you a lot about a boat. Here are foilers you can learn on, the ones at the Olympics, and the big boats you can watch race.

From club foilers to the Olympic classes to the professional circuits: each boat’s foils follow what it has to do, and where.

Foil choice follows the job: one-design simplicity for clubs, the rider as the height control on boards, active flight control on the professional boats, and class rules that set the limits, as on the IMOCA 60.

Start here club foilers

WASZP

T-foils · wand

A one-person foiling dinghy, built to be simple and tough. Lots of young sailors learn to fly on one.

A one-design foiler with a wand and flap like the Moth’s, but tougher and cheaper, with smaller sails for lighter sailors.

One-design hull, foils and rig, with smaller rigs for lighter sailors; mechanical height control, as on the Moth.

Where: clubs and regattas around the world

International Moth

T-foils · wand

The boat in the pictures on this page: a tiny, very fast one-person foiler, and the dinghy that made foiling popular.

A development class: within a few limits, builders may change almost anything, which is why the Moth led foiling for years.

A box rule (length, beam, sail area); the wand-and-flap system was refined here before it spread to other classes.

Where: clubs; the Moth Worlds, every year

At the Olympics Los Angeles 2028

iQFOiL

T-foil · the rider’s stance

The Olympic windsurfer. The board flies on one foil, and the rider keeps it level with their feet.

Olympic since Paris 2024. Height and pitch come from how the rider stands, pumps and trims the rig.

One-design board, foil and rig; no mechanism for height: the rider is the flight controller.

Watch: the Olympics, Los Angeles 2028

Formula Kite

T-foil · the rider’s stance

Kiteboarding at the Olympics: a kite, a small board and a long foil. The fastest sailing at the Games.

Olympic since Paris 2024. Riders choose from registered kites and foils, and fly the board with their stance and the kite.

Registered equipment from approved makers; no mechanism for height, as on the iQFOiL.

Watch: the Olympics, Los Angeles 2028

Nacra 17

Curved boards · T-foil rudders

The Olympic catamaran, sailed by a man and a woman together. It flies on curved foils.

A mixed two-person catamaran, flying since Tokyo 2020 on curved boards, with T-foil elevators on the rudders.

Curved daggerboards give lift and side force; the rudder elevators set the pitch; ride height is the crew’s job, through trim and weight.

Watch: the Olympics, Los Angeles 2028

The big races to watch

F50

T-foils since 2025 · flight controller

SailGP’s catamarans: the same boat for every team, racing in cities around the world at up to about 100 km/h.

A one-design foiling catamaran with a wing for a sail. One of the crew, the flight controller, holds the ride height. T-foils since 2025, L-foils before.

Wing sail, one-design; ride height held by the flight controller through the foils; titanium T-foil daggerboards fleet-wide since January 2025, in place of the L-foils raced since 2019.

Watch: SailGP, a season of grand prix

AC75

T-foils on canting arms · flaps

The America’s Cup boat: a monohull with no keel, flying on foils at the ends of two swinging arms.

One arm down and flying, the other raised clear of the water; the crew flies her with flaps on the foil wings.

Canting foil arms replace the keel; heave and pitch by wing flaps and the rudder elevator, under a flight controller.

Watch: the 38th America’s Cup, Naples, 2027

IMOCA 60

L-foils · no rudder foils

Big ocean racers, often sailed alone around the world. Their curved foils lift most of the boat, but she never quite flies.

18-metre monohulls with canting keels and L-shaped foils; with no foils allowed on the rudders, they skim rather than fly.

Foils through the hull sides, a canting keel, and no lifting rudders under the class rule: semi-foiling, built for the open ocean.

Watch: The Ocean Race, from January 2027; the Vendée Globe, November 2028

6Faster than the wind

Foilers can go two or three times as fast as the wind. Then the wind you feel always comes from in front, even when the real wind is behind you, and the sails are pulled in tight on every course.

The fastest sailing boats in the world race like this. That is where we are heading next.

With boat speed at two or three times the wind, the apparent wind stays well forward whatever the course: foilers sail “upwind” to the apparent wind all the time, even when heading downwind. The chart compares a dinghy, a beach cat and a foiler.

The racing boats built around this, SailGP’s F50s and the America’s Cup classes, come next.

AWA = atan2(sin TWA, cos TWA + k). At k = 2.5 the apparent wind sits within roughly 20° to 30° of the bow from beam reaching to deep downwind, which is why foiling racers gybe through about 90° downwind and their sails look much the same on every leg.

The boats built around this, SailGP’s F50 and the America’s Cup classes, come next.

The faster the boat, the lower its line: the wind it feels comes from further in front.Speeds as a fraction of the wind: dinghy 0.5, beach cat 1, foiler 2.5.Constant speed ratio for clarity; real polars vary k with angle.

7Where next